Dismiss Notice
We would like to remind you that we’re updating our login process for all 3CX forums whereby you will be able to login with the same credentials you use for the Partner or Customer Portal. Click here to read more.

Patton Call Pickup disconnects

Discussion in '3CX Phone System - General' started by simongurner, Jan 6, 2008.

Thread Status:
Not open for further replies.
  1. simongurner

    Joined:
    Nov 26, 2007
    Messages:
    1
    Likes Received:
    0
    We are using a patton 4114 with BT lines connected to each port. Connection to the system is fine and each line is authenticated, with the config file improted fine during setup.

    The problem we have though is everytime someone then picks up an incoming call, the call is then immendiately dropped (disconnected).

    Also, when ever we try to dial out, again the calls just get disconnect straight away.

    Has anyone got any ideas in where to look to solving this?

    Regards

    Simon Gurner
     
  2. robjbrad

    Joined:
    Dec 6, 2007
    Messages:
    6
    Likes Received:
    0
  3. robjbrad

    Joined:
    Dec 6, 2007
    Messages:
    6
    Likes Received:
    0
    Also, remove battery reversal from the disconnect signal options.
     
Thread Status:
Not open for further replies.