Dismiss Notice
We would like to remind you that we’re updating our login process for all 3CX forums whereby you will be able to login with the same credentials you use for the Partner or Customer Portal. Click here to read more.

Patton FXS not showing after upgrade from v14 to v15

Discussion in '3CX Phone System - General' started by bob222, Dec 19, 2017.

Thread Status:
Not open for further replies.
  1. bob222

    Joined:
    Oct 3, 2015
    Messages:
    24
    Likes Received:
    5
    I have a Patton SN4114 FXS 4-port gateway. It was working fine under 3CX v14 Standard Edition (Windows). After upgrading to 3CX v15 Standard Edition (Debian 9) it is still working fine. All 4 attached phones can make and receive calls, and I see the 4 ports listed on the Phones page. However, when I look at the FXS/DECT page, there is no device listed.

    Should I try to add the Patton device to the FXS/DECT page? Or should I just leave it the way it is ? It seems like it is "half configured" right now. I'm just wondering if this is okay, or will it cause issues down the road?

    Bob B.
     
  2. YiannisH_3CX

    YiannisH_3CX Support Team
    Staff Member 3CX Support

    Joined:
    May 10, 2016
    Messages:
    7,340
    Likes Received:
    533
Thread Status:
Not open for further replies.