Port Mapping Problems - Cisco Meraki MX80

Discussion in '3CX Phone System - General' started by Steven Cage, Aug 1, 2017.

Thread Status:
Not open for further replies.
  1. Steven Cage

    Joined:
    Feb 8, 2017
    Messages:
    11
    Likes Received:
    4
    We have V15.5 running on a server connected to the internet via a FritzBox with port forwarding enabled. We are migrating away to a Cisco Meraki MX80 but when I configure the same port forwarding rules on the MX80 I get problems with Full Cone Nat when running the 3CX Firewall Check. We only have a single static IP address so cannot use a 1:1 NAT Port Mapping. Does anybody have 3CX clients running on a Cisco Meraki?
     
  2. Steven Cage

    Joined:
    Feb 8, 2017
    Messages:
    11
    Likes Received:
    4
    upload_2017-8-3_9-50-39.png
    I managed to resolve the problem. It was me being stupid and not defining the 'Allowed remote IPs' addresses correctly.
     
    dkeethler likes this.
  3. Rob24h

    Joined:
    Mar 20, 2017
    Messages:
    69
    Likes Received:
    6
    I'm interested in purchasing a Cisco Meraki (coming from a Cisco RV082). How is VOIP working on it in your experience?
     
  4. Steven Cage

    Joined:
    Feb 8, 2017
    Messages:
    11
    Likes Received:
    4
    I have only just migrated to the Meraki MX80 this morning so have no real feedback yet. Having said that it appears to be working well so far as no complaints.
     
Thread Status:
Not open for further replies.