Port SBC to OpenWRT / DD-WRT

Discussion in 'Ideas' started by Silly English Kniggit, Nov 11, 2017.

Port SBC to OpenWRT / DD-WRT 4.5 5 4votes
4.5/5, 4 votes

  1. Silly English Kniggit

    Joined:
    Sep 13, 2017
    Messages:
    215
    Likes Received:
    76
    That would allow the SBC to be installed on a good range of router hardware that either may be in use anyway, or is cheaper than a Raspberry Pi - such as https://www.gl-inet.com/ar150/ which are around GBP £25

    Currently I can download two open source phone systems (yes, the entire PBX) for that platform - but not the 3CX SBC.
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
    accentlogic likes this.
  2. Sopock

    Sopock Member

    Joined:
    Jul 11, 2012
    Messages:
    448
    Likes Received:
    20
    They think it's not powerful enough?

    pfSense | QNAP
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
  3. accentlogic

    accentlogic New Member

    Joined:
    Nov 14, 2013
    Messages:
    161
    Likes Received:
    66
    We use the NetGear R7000 in many small locations. BCM4709 dual core processor at 1GHz with 128GB of flash memory. That should handle quite a few extensions. Less powerful systems might only support a few, but some locations only need one extension behind the SBC.

    These cost more than a Raspberry Pi, but if we can eliminate an extra device it would be worth it.