PORTech MV-374 setup and configuration assistance

Discussion in '3CX Phone System - General' started by kyar600, Jan 4, 2011.

Thread Status:
Not open for further replies.
  1. kyar600

    Joined:
    Aug 30, 2010
    Messages:
    3
    Likes Received:
    0
    Would anyone be able to assist with the above? I have already gone through the basic setup from the 3CX website.

    When I head over to the mobile status section of the unit the Motion State says "initing" and does not change. I currently have just one sim card attached to SIM 1.

    Thanks in advance.
     
  2. complex1

    complex1 Active Member

    Joined:
    Jan 25, 2010
    Messages:
    752
    Likes Received:
    38
    This has as far as i know nothing to do with the 3CX Phone System. This is a hardware problem.
    The MV-374 is a Quad SIM VoIP Gateway and has also 4 channels. So if you insert a SIM card into SIM 1 then after a while, say 1 minute, the Motion State of Mobile 1 should go to “Standby”, all other Motion States will stick by “initing”.
    Maybe a firware update of the MV-374 will solve your problem.
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
Thread Status:
Not open for further replies.