Problem with default Cisco SPA50x provisioning template

Discussion in '3CX Phone System - General' started by efounco, Jan 22, 2012.

Thread Status:
Not open for further replies.
  1. efounco

    efounco New Member

    Joined:
    Sep 28, 2011
    Messages:
    148
    Likes Received:
    3
    I ran across this today and thought I would share with everyone...

    There's a problem with the default Cisco SPA50x provisioning template that, by default, turns OFF the WMI when the phone is re-provisioned. This value should be commented out (or removed) so that the phone retains its MWI settings prior to re-provisioning. The problem is further compounded by the "periodic resync" feature that forces the phones to re-sync and re-provision if the MWI is on.
     
Thread Status:
Not open for further replies.