provision from SPA508 GUI

Discussion in '3CX Phone System - General' started by looker44, Sep 7, 2016.

Thread Status:
Not open for further replies.
  1. looker44

    Joined:
    Dec 31, 2012
    Messages:
    37
    Likes Received:
    0
    I need to manually provision a Cisco SPA 508G phone from the web interface. my problem is :

    1. I cant find my cheat sheets for this
    AND
    2. I don't have phone password so I cant just copy line 1 to new line 4 with correct extension parameters

    I am going to have to factory reset, then rebuild my line appearances

    any help for manual provision - several years ago(v11) I had same post but cannot find it
    I think it is something like this?
    fnc=sd+blf+cp;sub=<EXT1>@<PBX-IP>;nme=<EXT1>
    fnc=sd+blf+cp;sub=<EXT2>@<PBX-IP>;nme=<EXT2>
    fnc=sd+blf+cp;sub=<EXT3>@<PBX-IP>;nme=<EXT3>
    fnc=sd+blf+cp;sub=<EXT4>@<PBX-IP>;nme=<EXT4>
     
  2. looker44

    Joined:
    Dec 31, 2012
    Messages:
    37
    Likes Received:
    0
    I think I figured this one out. I found an old manual'd provision phone...
     
Thread Status:
Not open for further replies.