Provisioning Phones using Template Programming based on ext

Discussion in '3CX Phone System - General' started by JHeart, Dec 17, 2010.

Thread Status:
Not open for further replies.
  1. JHeart

    Joined:
    Sep 9, 2010
    Messages:
    1
    Likes Received:
    0
    I am trying to program some features for individual phones of the same type.
    I have Aastra 6757i phones and would like to customize certain features other than BLF on some but not all of the phones.
    I tried to use the IF and ENDIF commands to set up parameters based on the phone's extension number or MAC address but I could not get it to work.

    Any suggestions?
     
Thread Status:
Not open for further replies.