Provisioning Phones

Discussion in '3CX Phone System - General' started by Chad, Jul 6, 2017.

Thread Status:
Not open for further replies.
  1. Chad

    Joined:
    Jul 6, 2017
    Messages:
    20
    Likes Received:
    0
    Looking at the template for a Yealink T29/T23 what does IF blf# check for in the following. I thought it was looking to see if a button was programmed and if it was keep the setting but every time I re provision a phone it changes the type back to 0 and overwrites the saved settings.
    {IF blf3}
    linekey.5.line = %%Line%%
    linekey.5.value = %%blf3%%
    linekey.5.pickup_value = %%PickupValue%%
    linekey.5.type = %%DKtype%%
    linekey.5.label = %%blffirstname3%% %%blflastname3%%
    linekey.5.extension = %%PickupValue%%
    {ELSE}
    linekey.5.type = 0
    {ENDIF}
     
  2. ntnetzeband

    Joined:
    Jul 30, 2016
    Messages:
    64
    Likes Received:
    5
    I believe it means the BLF number in the BLF tab under the user's extension settings. So it's like an IF statement that says if BLF #3 is filled out then add the corresponding values to linekey 5 on the phone.

    upload_2017-7-6_12-36-32.png
     
  3. Saqqara

    Saqqara Active Member

    Joined:
    Mar 12, 2014
    Messages:
    841
    Likes Received:
    125
    As above, set the BLF keys settings within the console
     
    YiannisH_3CX likes this.
  4. Chad

    Joined:
    Jul 6, 2017
    Messages:
    20
    Likes Received:
    0
    Thanks that makes sense. I had to change the template then because 3cx template automatically assigns the first two buttons to line keys and we didn't want that. Very helpful knowing what these are and that I can get rid of them because I'm assigning buttons through templates.
     
Thread Status:
Not open for further replies.