Recommended FXO for overhead paging

Discussion in '3CX Phone System - General' started by leejor, Apr 2, 2016.

Thread Status:
Not open for further replies.
  1. leejor

    leejor Well-Known Member

    Joined:
    Jan 22, 2008
    Messages:
    10,356
    Likes Received:
    224
    Assuming that the paging system is capable of simply being plugged into a telephone socket, dialled, and it answers , you page, then you hang-up, then any basic, single line, ATA should work for you. There are a number available, here is a link to configuring the basic Cisco model(s).

    http://www.888voip.com/configuring-a-ci ... -with-3cx/

    An ATA has a FXS port, by the way, that goes to a phone (S=Set), a gateway has an FXO port (O=office, as in central office), it plugs into a phone socket in the wall.
     
  2. 12494

    12494 Member

    Joined:
    Apr 16, 2010
    Messages:
    280
    Likes Received:
    20
    SNOM PA1 is a good device and it has provisioning template in 3CX.

    Allen
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
  3. craigreilly

    craigreilly Well-Known Member

    Joined:
    Feb 1, 2012
    Messages:
    2,947
    Likes Received:
    178
    Snom is solid if you are connecting to existing Horns or Speakers. I've used Horns both with and without power. It does have a small amplifier built in and runs on POE.

    If you can get the budget - the CyberData VoIP Speakers are great.
    If you do not need zones - try 1 SIP Speaker then add slaves.

    I use this setup for a big Cubicle Area in a new office.
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
Thread Status:
Not open for further replies.