Dismiss Notice
We would like to remind you that we’re updating our login process for all 3CX forums whereby you will be able to login with the same credentials you use for the Partner or Customer Portal. Click here to read more.

Register PSTN to Lancom 1724

Discussion in '3CX Phone System - General' started by hardhat, Jun 24, 2007.

Thread Status:
Not open for further replies.
  1. hardhat

    Joined:
    Jun 15, 2007
    Messages:
    3
    Likes Received:
    0
    I am trying to register the PSTN line to a Lancom 1724 gateway.
    Well, and it does not work. I have checked the documentation for the other gateway.
    The problem might be that I can set a password in the SIP-PBX configuration of the gateway but no authentication ID. Any help is appreciated.
     
  2. Anonymous

    Anonymous Guest

    If there is a password most likely there will be an id somewhere.

    Could it be the name of the device?

    Alternative you can also set the option that no registration is required.

    I do not know the device, but have a go at the above suggestions.
     
  3. 5qg4

    5qg4 Active Member

    Joined:
    Jan 31, 2007
    Messages:
    643
    Likes Received:
    1
    This gateway should be for ISDN line
    Four ISDN ports (NT/TE) for 8 parallel ISDN channels

    It should be not for Analog PSTN lines. I just want to make sure that your existing telephone line type, ISDN or analog PSTN line? If ISDN, please try DID/DDI setting.
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
Thread Status:
Not open for further replies.