Remote Site with Raspberry PI SBC - Bandwidth Management?

Discussion in '3CX Phone System - General' started by millennium2, Jan 22, 2015.

Thread Status:
Not open for further replies.
  1. millennium2

    Joined:
    Apr 8, 2011
    Messages:
    55
    Likes Received:
    0
    Hi,

    I am running 3CX Cloud 12.5 and have a remote site using about 4 Yealink phones connected to a Raspberry PI SBC controller. All is running fine...but just in case, I would like to setup Bandwidth Management settings at the remote site via IP grouping.

    Should I group all the IP Phones and SBC Controller for BWM? Or does all the traffic go through the SBC controller, therefore only allocate BWM to the Raspberry PI SBC?

    Any advice would be greatly appreciated, thanks.
     
  2. leejor

    leejor Well-Known Member

    Joined:
    Jan 22, 2008
    Messages:
    10,360
    Likes Received:
    226
    Re: Remote Site with Raspberry PI SBC - Bandwidth Management

    I would say...the second one.

    http://www.3cx.com/blog/docs/3cx-session-border-controller/
     
  3. millennium2

    Joined:
    Apr 8, 2011
    Messages:
    55
    Likes Received:
    0
    Re: Remote Site with Raspberry PI SBC - Bandwidth Management

    Thanks leejor,

    That's what I suspected. If I end up having any problems, I will report back here for the benefit of everyone.

    Thanks again. :)
     
Thread Status:
Not open for further replies.