Dismiss Notice
We would like to remind you that we’re updating our login process for all 3CX forums whereby you will be able to login with the same credentials you use for the Partner or Customer Portal. Click here to read more.

Selecting specific trunks on a Sangoma A200

Discussion in '3CX Phone System - General' started by Operandi, Nov 5, 2014.

Thread Status:
Not open for further replies.
  1. Operandi

    Joined:
    Feb 8, 2013
    Messages:
    1
    Likes Received:
    0
    We are running a 3cx system with a Sangoma A200 with 4 FXO lines. The issue is that we have a direct corporate analog line coming out of a VOIP Gateway that we need to be able to isolate from the rest of the FXO lines. Is there a way to be able to dial a specific FXO port for when we need to make a call through to cooperate vs. the other three ports that connect the lines from our phone company?
    If we could set up our Sangoma card as two separate gateways in 3CX we could potentially use two different outgoing rules pointing to different lines, but so far we haven’t been able to figure out if this is something that is even possible with the A200 or 3CX.
     
  2. leejor

    leejor Well-Known Member

    Joined:
    Jan 22, 2008
    Messages:
    11,086
    Likes Received:
    325
    This question came up a few years ago. At that time it was suggested that this was not possible. I'm not sure if things have changed since then. http://www.3cx.com/forums/sangoma-a200-how-does-one-select-individual-pstn-line-21412.html

    If no one else on this forum responds, you might want to see if Sangoma has a forum. If the 200 can be broken down into multiple trunks, perhaps using ports, then it should not be difficult to have 3CX accommodate, that although you may have to configure the 200 manually.
     
Thread Status:
Not open for further replies.