Setup bridge question

Discussion in '3CX Phone System - General' started by hoosier1077, Mar 1, 2012.

Thread Status:
Not open for further replies.
  1. hoosier1077

    Joined:
    Mar 5, 2011
    Messages:
    52
    Likes Received:
    0
    Hello,
    I see in the bridge setup area there is a place for public and local ip for the 3cx servers, however if you already have the two locations communicating over ipsec, is there any need to included all of that info in the setup? That way I would only need to tell server A to look for server b's local ip address which it has full access to over that ipsec tunnel. Thanks for the help
     
  2. leejor

    leejor Well-Known Member

    Joined:
    Jan 22, 2008
    Messages:
    10,750
    Likes Received:
    285
    Haven't tried running the bridge over VPN, but, If it doesn't work, leaving the public IP blank, then try putting the local IP in both.
     
Thread Status:
Not open for further replies.