Sipgate and CallerID

Discussion in '3CX Phone System - General' started by Pentangle, Jan 4, 2008.

  1. Pentangle

    Pentangle Member

    Joined:
    Dec 6, 2007
    Messages:
    261
    Likes Received:
    0
    So I have a 3cx system at work, and a 3cx system at home. They both have a Sipgate VoIP line and everything works fine....

    ...except the Caller ID is reported as being the Sipgate SIP ID rather than the caller ID despite both Sipgate systems being set to deliver caller ID and both 3cx systems set to send caller ID.

    Any ideas?
     
  2. Wardy

    Wardy New Member

    Joined:
    Sep 18, 2007
    Messages:
    110
    Likes Received:
    0
    I am also using SIPGate and the lines show the correct number not the ID
     
  3. silentfun

    silentfun Member

    Joined:
    Dec 11, 2006
    Messages:
    364
    Likes Received:
    0
    also using sipgate but in v3 i have set it to anonymus to not send the number and it have worked not in v5 - until now i have not found where to do this now.

    atm he show the voip number to the caller and the caller numbers on y phones.

    Andy
     
  4. aryagohar

    Joined:
    Jan 20, 2008
    Messages:
    1
    Likes Received:
    0
    hi there

    i'd tried serveral ways, but when my voip gateway send the CallerID instead of the registration no.
    the call rejected by 3cx.

    I'm using v5 right now. but I have the same problem with CID.

    i tried AXON , with same configuration , it send teh callerID. i think this problem is a native bug of 3CX.
     

Share This Page