SIPIP6000 BLF For Shared Parking

Discussion in '3CX Phone System - General' started by davidc@allpax.com, Apr 30, 2015.

Thread Status:
Not open for further replies.
  1. davidc@allpax.com

    Joined:
    Jun 25, 2014
    Messages:
    15
    Likes Received:
    0
    I am trying to get the shared parking to show up in the Polycom IP6000 conference phone. I have updated to the latest firmware and the BLFs are configured in the management console, but they do not show up on the phone.
     
  2. Leonidas 3CX

    3CX Support

    Joined:
    May 6, 2015
    Messages:
    12
    Likes Received:
    0
    Hello David,

    Please make sure that after you perform the changes on the management console to press the apply button on the bottom of the page. Also Under extensions>>rights>> enable the allow parking option.
    After the changes reset and reprovision the phones via the management console.

    Thank you,
    Leonidas
     
  3. davidc@allpax.com

    Joined:
    Jun 25, 2014
    Messages:
    15
    Likes Received:
    0
    The phone has been reprovisioned, but parking is really not the issue. I cannot get any blfs to load through 3cx. The blfs on the phone do not update.

    Thanks
     
  4. Thomas 3CX

    3CX Support

    Joined:
    May 6, 2015
    Messages:
    15
    Likes Received:
    0
    Hello,

    You are using some custom or the default template for the Polycom IP6000 ?

    Thanks,
    Thomas
     
  5. davidc@allpax.com

    Joined:
    Jun 25, 2014
    Messages:
    15
    Likes Received:
    0
Thread Status:
Not open for further replies.