SIPURA 3000 GATEWAY REGISTRATION PROBLEM

Discussion in '3CX Phone System - General' started by calicheosorio, Jul 27, 2007.

  1. calicheosorio

    Joined:
    Jul 27, 2007
    Messages:
    1
    Likes Received:
    0
    Hello,

    I have a sipura 3k with a FXO enable port. I created on the 3cx box a new PSTN line with the sipura gateway, but it doesn
     
  2. 5qg4

    5qg4 Active Member

    Joined:
    Jan 31, 2007
    Messages:
    643
    Likes Received:
    0
    Do you have a firewall enabled at 3CX box? If yes. Please try to temporary disable it.
     
  3. Anonymous

    Anonymous Guest

    LOL, that happens everynow and then.

    If you are sure that the authentication details are correct but the line does not register try this.

    Configure 3CX first for this line.
    Then use the authentication details from 3CX and enter them in the PSTN line Subscriber section.

    Then do a reboot, either by removing the power or using
    For some reason 3CX must be configured first and then the SPA3102 Subscriber details.


    It is a rare issue but see if the above helps, it helped for me a few times.
     

Share This Page