SmartNode 4114 gateway configuration problem

Discussion in '3CX Phone System - General' started by giannilp, Mar 23, 2007.

Thread Status:
Not open for further replies.
  1. giannilp

    Joined:
    Mar 13, 2007
    Messages:
    1
    Likes Received:
    0
    Hi, I just configured smarnode 4114 as support page said, but it don't send a registration request to 3CX. ... the links are good and the gateway reach the 3CX server.

    here is the patton config:

    context ip router

    interface eth0
    ipaddress 192.168.1.4 255.255.255.0
    tcp adjust-mss rx mtu
    tcp adjust-mss tx mtu

    context ip router
    route 0.0.0.0 0.0.0.0 192.168.1.1 0

    context cs switch

    interface sip SIP-IF
    bind gateway 3cxpbx
    service default
    route call dest-interface fxo-00

    interface fxo fxo-00
    route call dest-interface SIP-IF

    context cs switch
    no shutdown

    gateway sip 3cxpbx
    bind interface eth0 router

    service default
    domain 192.168.1.195
    authentication 30002 password iQAbdwbb86U= encrypted
    default-server 192.168.1.195 5060 loose-router
    registration-lifetime 1200
    registrar 192.168.1.195

    gateway sip 3cxpbx
    no shutdown

    port ethernet 0 0
    medium auto
    encapsulation ip
    bind interface eth0 router
    no shutdown

    port fxo 0 0
    encapsulation cc-fxo
    bind interface fxo-00 switch
    no shutdown

    thanks for any suggestion
    Gianni
     
  2. 3CXsupport

    3CXsupport New Member

    Joined:
    Aug 21, 2006
    Messages:
    193
    Likes Received:
    0
    Hi please review the FAQ http://www.3cx.com/support/patton-smartnode.html to configure the smartnode.

    This is one of the hardest devices to configure and understand but it is a really well behaved device. You are going to require patience, but in the end it will pay off.
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
Thread Status:
Not open for further replies.