snom M300 / M25,M65

Discussion in '3CX Phone System - General' started by PatOne, Jul 20, 2015.

Thread Status:
Not open for further replies.
  1. PatOne

    Joined:
    Jul 20, 2015
    Messages:
    3
    Likes Received:
    0
    Hi,

    We use some Snom M65 and M25 (with M300 Base) as well as Yealink W52 handsets and were not able to automatically make a call from the softphone via CTI.
    It is neccessary to accept each call on the handset.
    Is there a way to auto-dial like all other phones do ? I mean the "Make Call" funktion.

    Thx
    Pat
     
  2. complex1

    complex1 Active Member

    Joined:
    Jan 25, 2010
    Messages:
    763
    Likes Received:
    39
    Hi Pat,

    The phone(s), in this case the M300 and W52P base, must support HTTP commands.
    If not, then only “make call” can be used.
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
  3. PatOne

    Joined:
    Jul 20, 2015
    Messages:
    3
    Likes Received:
    0
    Thx for your reply - do you know any wireless handsets that supports HTTP commands ?

    In the datasheet of the base station M300 I can see that HTTP protocol is supported.
     
  4. complex1

    complex1 Active Member

    Joined:
    Jan 25, 2010
    Messages:
    763
    Likes Received:
    39
    Not sure about, but what they mean under Specifications > Protocols with HTTP/HTTPS/TFTP is how you can Provisioning and/or do a Firmware upgrade for the base. This is not used for CTI commands.

    No. Is there any?
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
  5. PatOne

    Joined:
    Jul 20, 2015
    Messages:
    3
    Likes Received:
    0
    Good Question - hope there is one on the market !?
     
Thread Status:
Not open for further replies.