Dismiss Notice
We would like to remind you that we’re updating our login process for all 3CX forums whereby you will be able to login with the same credentials you use for the Partner or Customer Portal. Click here to read more.

Snom PA1 strobe

Discussion in '3CX Phone System - General' started by bbaker73, Oct 27, 2017.

Thread Status:
Not open for further replies.
  1. bbaker73

    bbaker73 New Member

    Joined:
    Nov 27, 2015
    Messages:
    144
    Likes Received:
    26
    Can anyone point me to any setup documents on wiring/configuring the Snom PA1 with a speaker and/or strobe? I'd like to set up paging to activate a strobe.
     
  2. eddv123

    eddv123 Well-Known Member

    Joined:
    Aug 15, 2017
    Messages:
    1,441
    Likes Received:
    189
    Hi bbaker,

    The PA1 is still supported in the 3CX>snom provisioning template.

    All the documentation I can find on the PA1 and 3CX can be found here:

    https://www.3cx.com/sip-phones/provisioning-snom-pa1/
    http://wiki.snom.com/Snom_PA1/Documentation
    http://downloads.snom.net/documentation/UM_PA1_en.pdf

    I used one of these with 3CX and a speaker and it worked perfectly well. Connect the devices wires to the speaker terminals labelled "Speaker". Connect the "+" wire with the red terminal, connect the "-" wire with the black terminal that should be it.
     
    bbaker73 and YiannisH_3CX like this.
  3. bbaker73

    bbaker73 New Member

    Joined:
    Nov 27, 2015
    Messages:
    144
    Likes Received:
    26
    Thank you!
     
Thread Status:
Not open for further replies.