[SOLVED] Use Bridge to access master outbound dial plan

Discussion in '3CX Phone System - General' started by stober, Oct 19, 2010.

Thread Status:
Not open for further replies.
  1. stober

    Joined:
    Jun 19, 2010
    Messages:
    14
    Likes Received:
    0
    Hi guys trying to figure out how to make a call from my slave to my master and then dial out using the master outbound dial plans. It seems to me the that the destinations on the master are fairly limited....

    any thoughts?



    stober
     
  2. leejor

    leejor Well-Known Member

    Joined:
    Jan 22, 2008
    Messages:
    10,362
    Likes Received:
    226
    Re: Use Bridge to access master outbound dial plan

    Have you tried just sending the digits used by a local extension to place an outbound call? You may have to create a new access code/outbound rule, on the originating board. like ...7+9+XXX-xxx-xxxx, strip the 7 and send the remaining out on the bridge. If the other PBX requires an access digit other than 9, then you have to substitute the correct digit.
     
  3. stober

    Joined:
    Jun 19, 2010
    Messages:
    14
    Likes Received:
    0
    Re: Use Bridge to access master outbound dial plan

    Tried that; 5 is my slave dial plan to over the bridge, 9 is my dial plan on the master out my analog line, and 4970560 is the number im trying to reach.

    so when dialing log shows something like the pbx is looking for 94970560@192.168.1.10 but cant be found.

    I will post some log tomorrow.



    Thanks
     
  4. stober

    Joined:
    Jun 19, 2010
    Messages:
    14
    Likes Received:
    0
    ugh, appears to have been a typo in my slave auth parameters....
     
Thread Status:
Not open for further replies.