SPA3000 problem

Discussion in '3CX Phone System - General' started by jason2nl, May 9, 2007.

  1. jason2nl

    Joined:
    May 8, 2007
    Messages:
    7
    Likes Received:
    0
    Hi,
    I am new here and want to try out 3CX because I think that there is much potential in it.

    I use the 3CX on a LAN with 3 softphones and a Sipura SPA3000 (Linksys).
    To make connections with the SPA3000 to third parties (voip providers) is not necessary.

    When I start up 3CX the SPA3000 registers right.
    The problem is that I lose registration of Line 1 after a couple of minutes.
    But the SPA3000 continues indicate that is Line 1 is registered.

    I have placed the configuration screens on the next internetsite: http://home.tiscali.nl/

    Can somebody help me ?
     
  2. Borsoock

    Borsoock New Member

    Joined:
    Apr 8, 2007
    Messages:
    149
    Likes Received:
    0
    Hi
    If I understand correctly you configured FXS port as VOIP provider instead of 'extension'? I don't think It's going to work that way.

    Some other suggestions:
    - Disable one line during tests to avoid interference: If both Line1 and PSTN are configured for UDP 5060 port, you will experience problems with concurrent usage.

    - Change preferred codec settings to G711a.


    Thanks

    Marcin
     
  3. jason2nl

    Joined:
    May 8, 2007
    Messages:
    7
    Likes Received:
    0
    Thanks Marcin (Borsoock),
    It is working now !
    I changed the FXS in an extention.

    Thankx,
    Jason
     

Share This Page