Dismiss Notice
We would like to remind you that we’re updating our login process for all 3CX forums whereby you will be able to login with the same credentials you use for the Partner or Customer Portal. Click here to read more.

spa3102 and traditional phone

Discussion in '3CX Phone System - General' started by akourou, Nov 4, 2008.

Thread Status:
Not open for further replies.
  1. akourou

    Joined:
    Oct 20, 2008
    Messages:
    10
    Likes Received:
    0
    hello,

    I have setup a configuration with a spa3102 as a pstn gateway, some spa942 as terminals and it all works fine.
    I have also setup the analog port of the spa3102 to be able to use a traditional phone as a terminal.
    From this traditional phone I can dial to the pstn and to the other terminals but it takes about 10 seconds from the time I finish dialing the number, to make the call.
    Note that when I call this traditional phone from the other spa942 terminals, it rings imediately.
    Is there a way to reduce this 10second delay?

    thank you
     
  2. galal202

    galal202 New Member

    Joined:
    Jun 23, 2008
    Messages:
    235
    Likes Received:
    0
    Hello and welcome,
    Modify your dial plan to make it dial directly after last digit
     
  3. akourou

    Joined:
    Oct 20, 2008
    Messages:
    10
    Likes Received:
    0
    you mean I have to go to the web interface of the spa3102 and modify a dial plan somewhere there?
    if yes, on which page exactly?

    thanx
     
  4. akourou

    Joined:
    Oct 20, 2008
    Messages:
    10
    Likes Received:
    0
    I modified the dial plan on the Line1 tab of the spa3102.

    it was (*xx|[3469]11|0|00|[2-9]xxxxxx|1xxx[2-9]xxxxxxS0|xxxxxxxxxxxx.)

    and I changed it to (xx.)

    now the time is reduced to 3 seconds

    is there a better way or it is ok?

    thanx
     
  5. galal202

    galal202 New Member

    Joined:
    Jun 23, 2008
    Messages:
    235
    Likes Received:
    0
    Hello,
    no you have to change all the dial plan
    it depend on your extensions numbers, outbound rules ..... etc
     
Thread Status:
Not open for further replies.