T46 dialing from MyPhone

Discussion in '3CX Phone System - General' started by craigreilly, Jul 15, 2013.

Thread Status:
Not open for further replies.
  1. craigreilly

    craigreilly Well-Known Member

    Joined:
    Feb 1, 2012
    Messages:
    2,969
    Likes Received:
    182
    I know that 3cx has not officially supported the new Yealink T4x phones... but has anyone been able to get MyPhone to dial/control the phone?
    I have the Remote information setup, using 'any for the IP Address for testing as I do not know if the phone server or the workstation actually sends the command. I have tested the string in Safari. And, after it tells me the website is fishing for my password (which it did with the T38 as well) it worked. (IE just says the website wasn't found... security BS I am sure because of the username/password string)

    I am using this string:

    Code:
    http://user:phonepw@phoneIP/servlet?number=%number%
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
  2. craigreilly

    craigreilly Well-Known Member

    Joined:
    Feb 1, 2012
    Messages:
    2,969
    Likes Received:
    182
    They have changed the authentication mechanism to forms based, instead of basic authentication. Therefor, the old dial string (T38) does not work. Yealink say they tried this:
    Code:
    http://10.2.20.20/servlet?number=948&username=admin&pwd=admin
    and it worked for them... I tried in IE and it redirected me to the logon page. I put it into the phone and did a Wireshark trace, and it to was redirected to the logon page.
    My guess it the Yealink Tech Support was already logged into the device when they sent the string...

    Anyone else have a T46 they can test this on?
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
Thread Status:
Not open for further replies.