Target endpoint for +5511XXXXXX can not be built!

Discussion in '3CX Phone System - General' started by daktur, May 17, 2016.

Thread Status:
Not open for further replies.
  1. daktur

    daktur New Member

    Joined:
    Oct 15, 2015
    Messages:
    226
    Likes Received:
    7
    Hi Everyone,

    I am trying to make outbound calls easier for everyone, and instead of asking everyone to dial 011 prefix, i tried to set up, in the outbound rule that every numer between 13 and 17 caracters starting with + to strip 1 digit and prepand 011.

    But every dial attempt after this config update gives the following error:

    17-mai-2016 18:47:20.001 [Flow] Target endpoint for +551131541000 can not be built!
    17-mai-2016 18:46:10.239 [Flow] Target endpoint for +551131541000 can not be built!
    17-mai-2016 18:45:53.307 [Flow] Target endpoint for +551131541000 can not be built!
    17-mai-2016 18:42:52.139 [Flow] Target endpoint for +551131541000 can not be built!
    17-mai-2016 18:42:13.645 [Flow] Target endpoint for +551131541000 can not be built!
    17-mai-2016 18:41:31.373 [Flow] Target endpoint for +972XXXXXXXXX can not be built!

    What does this exactly means?

    IS one of the settings wrong?

    Running v14sp3

    Thank a lot!
     
  2. leejor

    leejor Well-Known Member

    Joined:
    Jan 22, 2008
    Messages:
    10,732
    Likes Received:
    277
  3. daktur

    daktur New Member

    Joined:
    Oct 15, 2015
    Messages:
    226
    Likes Received:
    7
    Leejor,

    I have read but did not understand exactly how to fix it.

    It seems to be a different issue.
     
  4. leejor

    leejor Well-Known Member

    Joined:
    Jan 22, 2008
    Messages:
    10,732
    Likes Received:
    277
    By making use of the 3CX e.164 settings you should be able to change the + into the required (international/national) prefix to then be handled by the outbound rules (which may also have to be "revised")
     
Thread Status:
Not open for further replies.