Upgrade to SP6

Discussion in '3CX Phone System - General' started by ikonectu, Jun 20, 2014.

Thread Status:
Not open for further replies.
  1. ikonectu

    Joined:
    Mar 26, 2013
    Messages:
    16
    Likes Received:
    0
    I just upgraded to SP6. I cannot get the system to register the SN4112 since upgrade.
    I have re-generated the config file and imported into SN4112, Upgraded the SN4112 via 3CX. I see calls (via front panel LED) coming into the 4112 but cannot answer (obviously).

    When I check port & trunk status I get this message...
     

    Attached Files:

  2. craigreilly

    craigreilly Well-Known Member

    Joined:
    Feb 1, 2012
    Messages:
    3,069
    Likes Received:
    201
    Tried deleting device , readding it and then reconfige rules?
    Just a thought...
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
  3. ikonectu

    Joined:
    Mar 26, 2013
    Messages:
    16
    Likes Received:
    0
    Thanks CraigReilly.
    That is my "next step". This is my office NFR system. I am a little (a lot) reluctant to upgrade my clients if this is something that could happen to their systems.

    Anyone else out there had this experience?

    BTW - I really like the new management console. It does appear much faster.
     
Thread Status:
Not open for further replies.