Use IP in Contact to recognize source equivalent in 5.1?

Discussion in '3CX Phone System - General' started by ITWorks, Mar 6, 2008.

Thread Status:
Not open for further replies.
  1. ITWorks

    ITWorks New Member

    Joined:
    Apr 7, 2007
    Messages:
    121
    Likes Received:
    0
    With 3CX version 3.1 one could select “Use IP in 'Contact' to recognize source”. This would prevent the following error with calls through our Cisco 2811 ISDN PRI gateway.

    [CM010001] Line configuration does not allow identification of the source of this call. Check Advanced Options for Gateways and Providers and match a field to a correct value from the following: Contact IP: '10.10.30.13'; From: '9995553327'; To: '5556180'; Rline: '5556180'; Contact: '9995553327'

    I would like to know what the equivalent settings are to do this in version 5.1 as I have the same error but no obvious setting choice in the line settings. Any help would be greatly appreciated.

    Mark
     
Thread Status:
Not open for further replies.