Dismiss Notice
We would like to remind you that we’re updating our login process for all 3CX forums whereby you will be able to login with the same credentials you use for the Partner or Customer Portal. Click here to read more.

UTStarcom F3000 configuration

Discussion in '3CX Phone System - General' started by howser29, Apr 4, 2007.

Thread Status:
Not open for further replies.
  1. howser29

    Joined:
    Apr 4, 2007
    Messages:
    1
    Likes Received:
    0
    What are the SIP configuration steps for connecting a UTStarcom F3000 phone to the 3CX system. I have the phone connected to my wireless network, but it will not register with on the 3CX system. I have two of the Hitachi 5000 models that work great! Any help would be greatly appreciated.
     
  2. Costas3CX

    Costas3CX New Member

    Joined:
    Jan 23, 2007
    Messages:
    217
    Likes Received:
    0
    Hello. We haven't tested with that phone so I cannot send you exact directions on how to configure it. I have looked it up though and found this manual for it in case you didn't already know about this. I found that page 91-94 of this manual explains exactly which configuration changes you have to make, to get it to work. All you have to do is fill in the data provided in our manualfor configuring extensions (eg proxy IP, proxy port etc. ) and apply them to your device.

    And by the way, welcome to our forum howser29
     
Thread Status:
Not open for further replies.