VoIp Setup

Discussion in '3CX Phone System - General' started by Carlos Sosa, Feb 21, 2017.

Thread Status:
Not open for further replies.
  1. Carlos Sosa

    Joined:
    Feb 21, 2017
    Messages:
    1
    Likes Received:
    0
    Hello,

    I'm really new to the whole VoIP Thing. I'm currently remodeling a new main office in Caracas Venezuela for my company. In my main office I will have 5 Land (Regular-Analog) Phone Lines. What I would like to do is set up a VoIP System that uses my 5 Regular Land lines. I also would like to be able to setup additional offices and use the same VoIp System on all of them. Can I use 3CX for this and where can I find a guide to setup something like this.

    In help/guidance would be greatly appreciated.

    Carlos Sosa
     
  2. YiannisH_3CX

    YiannisH_3CX Support Team
    Staff Member 3CX Support

    Joined:
    May 10, 2016
    Messages:
    6,016
    Likes Received:
    421
    Hello @Carlos Sosa

    Assuming that the PBX will be in the same network as the analog phones then you can use an FXS device to connect the phones to the PBX. Basically an FXS device is a device that allows you to connect analog devices to the PBX. Below is a list of supported devices by the PBX.
    https://www.3cx.com/voip-gateways/

    You can then connect multiple remote locations either using remote extensions or bridges depending on your needs and the size of the remote sites.
    You can find more information by reading the admin guide found here: https://www.3cx.com/docs/manual/
    Regarding configuring remote extensions you can find more info here : https://www.3cx.com/3cxacademy/videos/intermediate/
    and https://www.3cx.com/blog/docs/provisioning-a-remote-extension/
     
  3. Sopock

    Sopock Member

    Joined:
    Jul 11, 2012
    Messages:
    447
    Likes Received:
    20
    Lost in translation? Maybe OP can confirm that intention is to use PSTN?:confused:

    [​IMG]
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
Thread Status:
Not open for further replies.