Solved Yealink 3CX Logo - can't disable on V15

Discussion in '3CX Phone System - General' started by Peter Richardson, May 8, 2017.

Thread Status:
Not open for further replies.
  1. Peter Richardson

    Peter Richardson New Member

    Joined:
    Apr 6, 2017
    Messages:
    165
    Likes Received:
    6
    Hi all,

    I am using Yealink T21P E2 and Yealink T41P phones. I am trying to disable the 3CX logo from flashing on the screen of the Yealinks. I have found this setting in the web interface of the phones, but if I reboot the phone, the setting is overridden by the provisioning from 3CX.

    I have had a look in 3CX under Settings -> Templates, but two problems remain:

    1) I can't edit the template from the 3CX web interface
    2) I don't know which template (exactly) that each phone uses as they are not clearly identified. I could assume the T41P uses the "yealinkT4x.ph.xml" template, but what about the T21P E2?
     
  2. YiannisH_3CX

    YiannisH_3CX Support Team
    Staff Member 3CX Support

    Joined:
    May 10, 2016
    Messages:
    5,425
    Likes Received:
    352
  3. Peter Richardson

    Peter Richardson New Member

    Joined:
    Apr 6, 2017
    Messages:
    165
    Likes Received:
    6
    Hey @YiannisH_3CX

    Thanks very much for your help, that was easy! Perhaps it could be made a little more intuitive on the PBX interface?
     
    myuniquename likes this.
  4. craigreilly

    craigreilly Well-Known Member

    Joined:
    Feb 1, 2012
    Messages:
    3,069
    Likes Received:
    201
    or replace the 3cx logo in the provisioning folder.
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
    Tim Steinhoff and AH2 like this.
Thread Status:
Not open for further replies.