Dismiss Notice
We would like to remind you that we’re updating our login process for all 3CX forums whereby you will be able to login with the same credentials you use for the Partner or Customer Portal. Click here to read more.

Yealink T28P No Message Light

Discussion in 'Windows' started by andrew.joiner, Dec 17, 2010.

Thread Status:
Not open for further replies.
  1. andrew.joiner

    Joined:
    Dec 17, 2010
    Messages:
    2
    Likes Received:
    0
    I have a Yealink T28P which has the latest firmware and latest 3CX Version. After the phone was provisioned, I tried to see if the message light will illuminate after leaving a message for the ext configured on the phone. The light doesn't turn on and the screen doesn't show any messages either.

    Does anyone else have this issue and/or possible way to fix it?

    Thank you all!
     
  2. leejor

    leejor Well-Known Member

    Joined:
    Jan 22, 2008
    Messages:
    11,095
    Likes Received:
    327
    Are you using the "free" 3CX version? If so then MWI will not work. You would need to apply the Demo code which then limits you to two concurrent calls, not four.
     
  3. mhanson

    mhanson New Member

    Joined:
    Nov 6, 2008
    Messages:
    186
    Likes Received:
    1
    Leejor is right, MWI is disabled in the free version.

    If you do have a licensed version, are the phones local or remote?
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
  4. andrew.joiner

    Joined:
    Dec 17, 2010
    Messages:
    2
    Likes Received:
    0
    That was it - had to put in a key for it to work.

    Thanks all.
     
Thread Status:
Not open for further replies.