Yealink T46 power saving mode on firmware

Discussion in '3CX Phone System - General' started by Kristof Kuderko, Feb 15, 2018.

  1. Kristof Kuderko

    Nov 10, 2017
    Likes Received:
    My phones are T46G and T46S
    Firmware Version
    Hardware Version
    The power saving mode is disabled by template setting
    features.power_saving.enable = 0
    and it works BUT after the phone is rebooted it goes to power save mode after 30 mins (i think it's the default value), screen goes black. BTW I managed to switch off the infamous power LED blink on power save.
    When the display is waken up from power save by pressing any button, the phone never goes to power save again (expected)
    So, only that initial restart puts phone in power mode.
    Is it a bug? expected behaviour? anyone knows?
    it wasn't like that in v81 firmware. Only appeared in v82
    Please help