On this topic
With over 20 years of telecoms expertise, French solutions provider Linkt has a large portfolio of substantial customers who rely on their services. With their powerful platform, Linkt offers a secure and reliable solution that enables businesses to simplify their communications and save significantly on telco costs. Find Linkt’s SIP trunk in the 3CX management console.
Reference website: Linkt
Before configuring the SIP trunk it is required to go through the following checklist and make changes where necessary:
- NAT (when used) created to 3CX
- Firewall Checker passed
- Firewall SIP ALG checked and if present disabled
Further setup information can be found in our Academy: 3CX Academy Basic Course
Some providers gained support and compatibility with 3CX on a specific product version. It is advisable to always run the latest version of 3CX to ensure ongoing compatibility.
Minimum 3CX Version: 3CX v15.5 SP6
Below is a short overview of the provider's capabilities and services and whether they’re supported or not:
- CLNS (Clip No Screening): Yes
- Catch All Routing: Yes
- Fax T.38 support: No
- CLIR (Number Suppression): Yes
- DTMF via RFC 2833: Yes
- Codec Order: G711A
- NAT Support: Yes
Configuring the Trunk with 3CX
The general instructions outlining how to add a new SIP Trunk to your 3CX installation can be found here.
Adding the Trunk
Go to “SIP Trunks” and select “Add SIP Trunk”
- Select Country: FR
- Select Provider in your Country: Linkt
- Main trunk number: This will have been provided to you by Linkt. You must enter the number in the national number format (e.g.0123456789)
- Press OK
Since Linkt does not require authentication scroll to the top of the page and press OK. At this point you should see your Linkt Trunk appear as Registered.
Adding Additional DIDs
To associate all other DIDs/Numbers you have in your Linkt account with 3CX, go to the Management Console → SIP Trunks, double-click on your Linkt Trunk and go to the “DIDs” tab.
Here you should already see 1 entry; that is the Main Trunk number you have set. Add all other DIDs/Numbers you have to the list in the national number format (e.g. 0123456789) and press OK.
Creating Inbound Rules
Now that you have associated all your DIDs/Numbers with your SIP Trunk in 3CX, you can create Inbound Rules to set where calls will be routed when those numbers are called. Instructions on how to create Inbound Rules can be found here.
When configuring Linkt SIP Trunks in 3CX, all numbers should be entered in the national number format (e.g. 0123456789), otherwise call routing will fail.
Outbound Caller ID
Linkt Trunks support Clip No Screening which means you can present any number you want when calling outbound. For this to work however, in any place in 3CX that sets the Outbound Caller ID, you must insert the number in the national number format (e.g. 0123456789).
When configuring your Outbound Rules make sure that all numbers are dialed either in the National (e.g. 0123456789) , International (e.g. 0033123456789) or E164 format (e.g. +33123456789). More information about how to create Outbound Rules and how they work can be found here.