Weepee - SIP Trunk
On this topic
Weepee is one of the first Internet Telephony Service Providers in Belgium founded in 2004. With a brand portfolio of innovative solutions and exceptional experience in VoIP services, Weepee Telecom has been established as a major player for enterprise telephony.
Reference website: Weepee
Before configuring the SIP trunk it is required to go through the following checklist and make changes where necessary:
- NAT (when used) created to 3CX
- Firewall Checker passed
- Firewall SIP ALG checked and if present disabled
Further setup information can be found in our Academy: 3CX Academy Basic Course
Some providers gained support and compatibility with 3CX on a specific product version. It is advisable to always run the latest version of 3CX to ensure ongoing compatibility.
Minimum 3CX Version: 3CX Phone System 15.5 SP2
Below is a short overview of the provider's capabilities and services and whether they’re supported or not:
- CLNS (Clip No Screening): No
- Catch All Routing: Yes
- Fax T.38 support: Yes
- CLIR (Number Suppression): Yes
- DTMF via RFC 2833: Yes
- Codec Order: G711U, G711A, GSM-FR
- NAT Support: Yes
Configuring the Trunk with 3CX
The general instructions outlining how to add a new SIP Trunk to your 3CX installation can be found here.
Adding the Trunk
Go to “SIP Trunks” and select “Add SIP Trunk”
- Select Country: BE
- Select Provider in your Country: Weepee
- Main trunk number: This will have been provided to you by Weepee. You must enter the number in the international number format (e.g. 322033272020)
- Press OK
Under the “General” tab in the “Trunk Details” enter the registrar, and in the “Authentication” section your Authentication ID and Password (these will be supplied to you by Weepee).
Once you have filled in these fields as given to you by Weepee, scroll to the top of the page and press OK. At this point if you refresh the page you should see your Weepee Trunk appear as Registered.
Adding Additional DIDs
To associate all other DIDs/Numbers you have in your Weepee account with 3CX, go to the Management Console → SIP Trunks, double-click on your Weepee Trunk and go to the “DIDs” tab.
Here you should already see 1 entry; this is the Main Trunk number you have set. Add all other DIDs/Numbers you have to the list in an international number format (e.g. 322033272020) and press OK.
Creating Inbound Rules
Now that you have associated all your DIDs/Numbers with your SIP Trunk in 3CX, you can create Inbound Rules to set where calls will be routed when those numbers are called. Instructions on how to create Inbound Rules can be found here.
When configuring Weepee SIP Trunks in 3CX, all numbers should be entered in an international number format (e.g. 322033272020), otherwise call routing will fail.
Outbound Caller ID
Weepee Trunks do not support Clip No Screening which means you can’t present any number you want on outgoing calls. You can of course present any of the Numbers/DIDs you have associated with your account as Outbound Caller ID. In order for this to work, in any field within 3CX that sets the Outbound Caller ID, the number must be entered in International format (e.g. 322033272020).
When configuring your Outbound Rules make sure that all numbers are dialed either in the National (e.g. 02033272020) or International (e.g. 00322033272020) format.
More information about how to create Outbound Rules and how they work can be found here.