fanvil x3sg

  1. texmansru47

    Fanvil X3C - Not Registering

    Good Morning, I have two Fanvil Phones (X3G) (registered as a X3SG). They used to work. I changed SIP Trunk providers and everything is setup correctly but I cannot get these phones to register. They look correct on the 3CX Side but when I did a factory reset on them and tried to register...

  2. Fanvil stuck on 3CX logo

    Hey all, I've got a Fanvil X3SG that would not go past the initial 3CX splash screen. The L1 and L2 buttons are lit solid yellow, and the status LED is solid red. I've tried holding down # while powering up (as I've done on many Fanvils before), but the phone would not boot into post mode. Only...
  3. montri

    Solved Fanvil X3SG and X210i is not working on Call Pickup

    Hi, I have now using supported firewall by 3CX for Fanvil X3SG (FW 2.4.7) and X210i (1.10.15) and I found the problem that the dial code for Call Pickup is not working, whenever I pressed the dial code (I set *40) the voice promte say "voice mail is not enable" (which it not any thing relate...
    • montri
    • Thread
    • callpickup fanvil fanvil x3sg
    • Replies: 2
    • Forum: Fanvil
3CX Logo Footer Copyright © Sitemap Privacy
Top Bottom