Recent content by OdyNet

  1. Create Public SBC

    This conversation started based on the use of a SBC on the server side with a VPN connection to the branch locations where desk phones will be. Wanted 1 SBC for multiple branch locations as opposed to multiple SBCs at each branch location. I’ve figured it out though, but I appreciate your insight.

  2. Create Public SBC

    This is correct, though the limitation in which I would want to use the 3CX SBC is on 3CX. I have accepted this limitation and well move forward with SBCs at each remote location even if the remote location has only a single IP phone. Thank you for all of your input and support.

  3. Create Public SBC

    I'm not sure what you're getting at? Is this in reference to an SBC? I can put an SBC on just about anything .. that's not an issue.

  4. Create Public SBC

    You and many others advocate for these router phones and I'm not saying that isn't an easy solution .. in fact, I agree .. but when I have an inventory of hundreds of phones that are not router phones that are still supported by 3CX, reinvesting in router phones seems very much like an expensive...

  5. Create Public SBC

    I understand, now. In my experience STUN still requires configurations on the router/firewall side even if there is a single desk phone from a remote location. STUN is also less secure as previously pointed out. I'm trying to simplify deployment for remote users, but I understand the...

  6. Create Public SBC

    Apologies for not finding this link sooner (Hosted with 3CX - Explained). I've just seen other Cloud-Based VoIP providers like GoTo Connect (formerly Jive Communications) and Intermedia Elevate provide what I'm looking from from 3CX with services referred to as BYOP (Bring Your Own Phone). You...

  7. Create Public SBC

    Needing an SBC for a cloud-based deployment does not make sense. Router phone? Maybe. If I had to go and install an SBC at every location where I have a cloud-based instance, I might as well go back to self-hosted.

  8. Create Public SBC

    I have some correctiions and additions for this. Provisioning is done by the PBX, anyway, as long as port 5001 is open as per standard 3CX router/firewall configurations (3CX Firewall & Router Configuration). What I needed to do to get provisioning to operate was to force certain provisioning...

  9. Create Public SBC

    I setup a remote PBX and SBC on the same internal subnet and each has a NAT to different public addresses. The SBC shows in 3CX SIP settings as being properly registered. This confirms that the SBC works with PBX locally which should be a given. Now, from another remote location, on a Yealink...

  10. Create Public SBC

    I appreciate your comment, but this is not answering my question. As I previously mentioned, I am fully aware of and successfully deployed nearly every way to provision and register an IP phone. I am, very specifically, asking if I can create a public SBC and if I can, what needs to happen to...

  11. Create Public SBC

    Forgive me for not clarifying. I am aware that the SBC normally resides on the same subnet as the IP Phones. I'm also aware that there are IP Phones with SBC functionality built in. Essentially, I am aware of nearly every configuration based on 3CX documentation to configure, manage, and...

  12. Create Public SBC

    Can I create a Public SBC so that I can send preconfigured IP Phones out and have them provision (see image below)? I would prefer to not have to send an SBC out with every desk phone. I am aware this would be for a Self-Hosted or On-Prem instance, but there is virtually no documentation...
    • OdyNet
    • Thread
    • public sbc sbc
    • Replies: 29
    • Forum: SMB
See more
3CX Logo Footer Copyright © Sitemap Privacy
Top Bottom