Hello all,
Recently noticed that the "Enable hotdesking" checkbox in the user options is greyed out for all of users. I am trying to add a new user and cannot enable hotdesking. It is even greyed out for users who previously had it enabled.
Any ideas on what this could be? Just as reference...
Any help is appreciated.
Yealink T57W, latest 3CX Firmware on the phone.
Hotdesking (Yealink T57W) 3CX V20 U5,
When the user doesn't have an assigned permeant endpoint hotdesking works as expected.
When the user does have an assigned permeant endpoint (Yealink T57W) hotdesking doesn't work as...
We recently upgraded our 3CX system from V18 to Version 20.0 U3 remotely. Post-upgrade, we tested all functionality successfully, except for Hotdesking.
When testing Hotdesking onsite, users encountered an "Access Denied" message when dialing the feature access code to log in. Despite attempts...
Yealink T48S added as a Hot Desking phone on V20 (off premise), always shows no service. Dialing *77* code gives a busy tone.
I added Yealink T48S as a Hot Desking phone on V20 (off premise), then reset phone to factory defaults but after boot, it always shows no service. After reboot, I see...
We have noticed that when logging into a hotdesk phone it can take 5 minutes to provision for the extension.
Is this normal, I'm sure it used to be within a minute.
I have confirmed the time on both the Azure VM and SBC are the same.
We are running the following:
Azure Hosted 3CX v18.0.5 on...
Hi
We have a ~200 extension v18 Windows system hosted in Azure with Yealink IP Phones in the offices connected via ipsec/site to site VPNs. Currently phones are provisioned using option 66 in Local LAN mode, with a local DNS zone and A record to send the 3cx FQDN traffic up the VPN to the...
Hello !
When setting up an Hotdesk and configuring the RTP Encryption (SRTP) to Compulsory via the Phone Web admin, users cannot login anymore.
Dialing *77*XXX* = Not Acceptable here error
Of course it is possible to de-activate the SRTP encryption.
But when logged-in user then calls an...
Hello,
I am testing the hotdesking feature following this video ().
I am using a Yealink T19P E2 and a T21P E2 to test. I can successfully assign the hotdesking special extensions to them and from the management console I can see they are provisioned. I then setup two extensions for testing...