I have a Snom 370 already provisioned to an Epygi PBX which I need to keep. But I'd like to use one of the remaining seven "ID" channels on the Snom to *also* register it as an extension on the 3CX.
If I fill in the MAC address and phone type, I assume 3CX will "grab" the phone and over-write the existing config. Is there any way I can tell the auto-prov mechanism to leave ID1 alone and program ID2 instead? Or will I have to go manual?
(I'm surprised there isn't more info on this as almost all "posh" brands of phone support multiple connections.)
If I fill in the MAC address and phone type, I assume 3CX will "grab" the phone and over-write the existing config. Is there any way I can tell the auto-prov mechanism to leave ID1 alone and program ID2 instead? Or will I have to go manual?
(I'm surprised there isn't more info on this as almost all "posh" brands of phone support multiple connections.)
