Copied Debian VM to new location

[BCS-Tech]

I got the Debian 10 ISO installed a couple of weeks ago at one location. It is running as a VM on and Windows server. Works good.

I exported the the VM and copied to a new location. Booted the VM and changed the static IP address. All of that is good.

But I don't seem to be able to change the settings of the 3CX SBC. The 3cxsbc.conf file says it is recreated on each reboot.

Is there a way to re-run the initial setup of 3CX SBC or to remove it and Re-install O I can put in the new information?

Thanks

 

[SweetAction]

These 2 posts may be of interest:

https://www.3cx.com/community/threa...rom-onsite-to-hosted-by-3cx.76500/post-348467
https://www.3cx.com/community/threa...d-rewriting-etc-3cxsbc-conf.67574/post-293083

 

[Saqqara]

Why not start again, being a sbc server it will not take long

https://www.3cx.com/docs/3cx-tunnel-session-border-controller/#h.9hcxdspxfvz