Fanvil V Pro Series

[kent3]

Hi

Do we know if the V Pro series will be 3CX approved soon? I have a client that is keen on a wireless handset setup (not DECT) didn't want to go down the Yealink route as thats a bit out of his budget and we mainly use Fanvil.

Will the V62 template work on a V62 pro? Anyone tested or similar?

 

[boldtech]

I know I'm using the v65 template for the new V66 Pro phone successfully. I started another thread last week asking about the v66 template as well. =)

 

[kent3]

I know I'm using the v65 template for the new V66 Pro phone successfully. I started another thread last week asking about the v66 template as well. =)

Nice one. Thanks for the info!!

 

[boldtech]

I will say I can't assign a PNP-detected phone to an extension, the option is greyed out. I can only manually assign to an extension, but then it works fine.

 

[kent3]

I will say I can't assign a PNP-detected phone to an extension, the option is greyed out. I can only manually assign to an extension, but then it works fine.

Thanks for the heads up, so you are using + Phone in the Users/IP Phone tab? As long as its properly provisioned, that works for me.

 

[boldtech]

Thanks for the heads up, so you are using + Phone in the Users/IP Phone tab? As long as its properly provisioned, that works for me.

Correct, just added IP hone under the user extension using the MAC address. Factory reset the Fanvil and it comes right up.

 

[gcq1]

Using the V65 template, only the first nine BLF's appear on the phone.

 

[dLinc]

Using the V65 template, only the first nine BLF's appear on the phone.

i got the same thing. Provisioning works like butter, but only the first 9 BLF works.
can we manually change the config file to get more BLF's to work?