Set a Static Outbound Mask Number

[ZCSFT]

I need to set a static outbound mask. I have tried all the things below and no luck. Any Suggestions?

https://www.callacloud.com/support/inbound-outbound-caller-id-settings-in-3cx-with-callacloud/

https://support.flowroute.com/31949...lick Outbound Parameters . ... More items...

 

[leejor]

What do you mean by an "outbound mask"? You mean a static caller ID, on all calls?

 

[ZCSFT]

What do you mean by an "outbound mask"? You mean a static caller ID, on all calls?

Yes, something that shows the company's Main number. But that Main number isn't tied to 3CX (long story), so it needs to be something I can type in

 

[jcostlow]

If the carrier supports clip no screening you can make your outbound rule apply the caller ID.
https://www.3cx.com/docs/manual/sip-trunks/

Would need to be in whatever format the carrier expects calls in. I.E. 10 digit, 11 digit or E.164

 

[Juan Marriott]

If the carrier supports clip no screening you can make your outbound rule apply the caller ID.
https://www.3cx.com/docs/manual/sip-trunks/

Would need to be in whatever format the carrier expects calls in. I.E. 10 digit, 11 digit or E.164

It has to be allowed by the sip trunk provider; some countries do not allow

 

[YiannisH_3CX]

Hi @ZCollins-SFT

Both guides you are referencing are ancient at best so here is a guide on how to set it up in a newer version of 3CX.
In short you can specify a caller ID in your outbound rules. If your provider supports it then it should work.