Recent content by roi

  1. Unanswered calls

    1.I changed unanswered calls = yes (etc/asterisk/cdr.conf), reload, but it is not working, logs are not showing any changes on CDR? How do I enabled it? 2. Can we edit the CDR disposition and add new ones? when you callout/callin and you did not answer, it is showing "no answer". we need to have...
  2. Call logs / Reports

    Is these calls INCOMING? cannot find any details regarding the calls, no recording also. Is this hack? Where can i check? Thank you
  3. Slow Installation with Raid Implementation

    Support, I am setting up a test server with raid1 settings. Elastis 2.4 stable version. It is taking hours to finish the installation. What could be causing it? I am using 8gb memory Intel zeon 2.4ghz 8 cores. 2x Hdd 160gb. All sata. tried on two different server and two different cds. The...
  4. Manual Dial Call Center Addon

    Guys! Is it possible to do manual dial out on call center add on. I've tested this "http://www.elastix.org/index.php/en/component/kunena/19-call-center/86363-manual-calling-facility-through-call-center-modul.html" but it is not working on the latest version of Elatix. We can do manual dial...
  5. changing recording location

    Hello! I added another hard drive on my box, I want all calls recording including voice mail to be saved on the second hard drive. I'm having trouble mounting it with the right path. Can someone share some knowledge? Thank you!
  6. TDM410P

    Purchased digium TD410P, installed and detected through hardware detector (2 fxo and 2 fxs) Span # 1: WCTDM/0 "Wildcard TDM410P Board 1" (MASTER) What is the next step?
  7. Raid Recovery

    Been trying to setup Raid on my box, setup all went well, followed each step on the pdf guide, the problem is when i tested replacing one of the hard drives to make raid recovery, it wont boot. root (hd1,0) Error 22: No such partition Press any key to continue... But I was sure that raid was...
  8. Attended Transfer Ring time

    Hello Guys, How can we make the attended transfer ring time longer? After three rings it goes back immediately. I've been searching forums with no luck. Can someone share some light here? Thank you!
  9. Sangoma UT50 VoiceTime

    Hi Everyone, Can someone share some details on how to install sangoma ut50 voicetime on elastix! Thank you!
  10. No Reboot!

    Hello Guys! What can you advise regarding " no reboot". Is it possible that the box can run normally without restart? Please advice!
  11. dial 9 to use pstn line

    I am lost here, can someone share some info how to do this? Thank you in advance.
  12. UNISTIM still crashing asterisk

    hello... has anyone tried using i2004 nortel phones on the latest elastix version? I managed to registered the phones but every time you answer the phone asterisk crushes. any updates or patches??? Thank you.
  13. Nortel i2004 on asterisk 1.8

    Hey guys... I managed to register i2004 nortel phones on my elastix box. I found issues, and I cannot continue testing it. Can call other phones but you cannot hear anything on nortel phone, and as soon as I pickup the nortel phone it crashes the asterisk. I read that there is still a bug on...
  14. elastix with nortel

    hello guys! need a help here, we need to interconnect elastix with an existing nortel pbx, nortel can provide me digital line, is it possible that the two pbx can communicate, or analog line from nortel is better? Is this doable? we need elastix to dial nortel extensions, vice versa. Thank...
  15. echo on phones

    Hello. I'm having issues regarding very bad echo on internal calls(sip to sip) when both of them are using speakerphones, when both are using handsets everything is ok, and if one is using handset and the other line is on speakerphone it is ok as well. I've tried changing all the settings on the...