3CX and Bandwidth.com

[php master]

Hi Guys,

I need a hep to set up a Sip Trunk with Bandwidth.com, i am looking to have a minimal configuration for just one person (Myself).

Thank you

 

[Sopock]

Perhaps talk to an Expert on their site? It seems that static IP is required!

The SIP trunks are vastly more expensive than just using the API. I simply want to make and receive calls using only the API. Not the trunks.

SIP endpoints

[email protected]

 

[StefanW]

This is for sure as it can be seen here

https://www.3cx.com/partners/sip-trunks/usa/

Let me see if we can get our hand on the portal as u see it to document it...

 

[php master]

Perhaps talk to an Expert on their site? It seems that static IP is required!
SIP endpoints

[email protected]

I am a beginner and still not sure how i should call the API from the 3CX itself.

This is for sure as it can be seen here

https://www.3cx.com/partners/sip-trunks/usa/

Let me see if we can get our hand on the portal as u see it to document it...

I checked this page before and it doesn't have any helpful information it's just some VOIP providers.

I appreciate your time guys

 

[StefanW]

I am a beginner and still not sure how i should call the API from the 3CX itself.

From 3CX there is no API to BW it self, the trunk needs to be set at BW end and the same config needs then to be placed into 3CX.
If you want to go "automated" you could write a tool which uses on our end the "Call Control API" and parse the data from the API to us to create a trunk....

 

[Sopock]

But note that from above guide it is possible to register SIP client:
For testing purposes, download a SIP client like yate and setup your username, password and realm, you can retrieve your endpoints as follows.