3cx SPA3000

[madness007]

Hi, I'm new at 3cx.
I've a fresh install of 3cx with just a smartphone and a laptop (for now).
The purpouse of this install is to make calls trough my home analog pstn line.
I've a linksys SPA3000 (I know this model isnt supported by 3cx, But I alreaddy had this device at home).
I tried so many things to make it work, but i'm constantly getting stuck.
I found these following articles:

https://www.3cx.com/sip-phones/linksys-spa-921/
https://www.3cx.com/docs/manual/configuring-voip-gateway/

I did the following in 3cx:
- I created a user with extention 110
- I created an outbound rule with the gateway explained below
- Created a gateway with the ip of the SPA3000
This is the point where i got stuck.
There's a setting under the gateway settings called: route calls to->Main Trunc No
I don't know what to fill in there. I can't fill in 110 (the minimuum is 4 digits)


I can't get any further :/

some extra info:

3cx IP: 10.0.4.2
SPA3000 IP: 10.0.4.3

SPA3000 config: (de SPA3000 has 1(pstn) and 1(telephone-1) port)
I haven't configured the "pstn line" settings (for now, because I'm stuck)

I configured the following on the setting page "Line 1"
Proxy: 10.0.4.2

Subscriber info:
display name: SPA3000
Password <password given in 3cx gateway setting>
Auth ID: 10000 (from 3cx gateway setting)
User ID: 110
Use Auth ID: [YES]


Can someone help me further to set this up pls?
I'm a student in the IT, And i really want to start experimenting with 3cx.
My goal is to go for the 3cx certified badge after I'm used to this loveley system

 

[leejor]

Other than missing a router, and fewer options, the 3000, for 3CX, is configured the same way as a 3102.
Have a read through this, I just went through the complete setup with someone else.

https://www.3cx.com/community/threads/temporary-fxo-for-pstn.84112/

You will want to use a (Generic) trunk number, that you have created in 3CX, not an extension number (110), at least until you choose to setup the FXS port. You will also be using the PSTN line. Line 1, the FXS port, can, later, be setup. as an extension, if you wish. At this point, I think you are confusing, what the PSTN (FXO) and Line 1 actually do.