Greetings All:
I didn't update to 4510 yet, I usually wait and watch others for a couple of weeks before jumping to the latest versions :| (I'm still on version 5.1.4128.0)
My question is about the following mention: "Fixed: Wrong state of call shown in line status if outbound rule is assigned to more than 1 line."
In my experience, the problem was well beyond the status shown, I was having my calles dialed out on two lines simultaneously in so many instances that I gave up on the use of that capability (that is using an alternate route in an outbound call rule-definition when the first route is busy). Worse, after that happened one of the two lines would remain open until timeout occurred, and in some instances it wouldn't time out for tens of minutes (or maybe more - I never waited long enough to figure that out).
Was this the issue that got fixed? Or my experience is isolated and wasn't the focus of this fix.
Thanks.
Halea
I didn't update to 4510 yet, I usually wait and watch others for a couple of weeks before jumping to the latest versions :| (I'm still on version 5.1.4128.0)
My question is about the following mention: "Fixed: Wrong state of call shown in line status if outbound rule is assigned to more than 1 line."
In my experience, the problem was well beyond the status shown, I was having my calles dialed out on two lines simultaneously in so many instances that I gave up on the use of that capability (that is using an alternate route in an outbound call rule-definition when the first route is busy). Worse, after that happened one of the two lines would remain open until timeout occurred, and in some instances it wouldn't time out for tens of minutes (or maybe more - I never waited long enough to figure that out).
Was this the issue that got fixed? Or my experience is isolated and wasn't the focus of this fix.
Thanks.
Halea
