- Joined
- May 4, 2022
- Messages
- 66
- Reaction score
- 10
Hi,
Our switches have MAC authentication enabled so that only authorized devices can connect to the network. In some offices, we only have 1 network port available and it's difficult to lay new cables in due to several issues, so we end up connecting the Yealink T31G's WAN port to the wall and then connect the desktop to the Yealink's PC port. We then configure in 3CX under Advanced, the VLAN IDs for each port (70 for WAN 121 for PC). We do register the MAC of both the PC and the Yealink.
Problem is, there doesn't seem to be a consistent way that the MACs are assigned the VLAN on the switch. Sometimes the PC's MAC address gets assigned VLAN 70 instead of VLAN 121. Sometimes, both the phone and PC are assigned the same VLAN, sometimes the same MAC address gets assigned different VLANs.

What's the correct way to configure this so that it works?
Our switches have MAC authentication enabled so that only authorized devices can connect to the network. In some offices, we only have 1 network port available and it's difficult to lay new cables in due to several issues, so we end up connecting the Yealink T31G's WAN port to the wall and then connect the desktop to the Yealink's PC port. We then configure in 3CX under Advanced, the VLAN IDs for each port (70 for WAN 121 for PC). We do register the MAC of both the PC and the Yealink.
Problem is, there doesn't seem to be a consistent way that the MACs are assigned the VLAN on the switch. Sometimes the PC's MAC address gets assigned VLAN 70 instead of VLAN 121. Sometimes, both the phone and PC are assigned the same VLAN, sometimes the same MAC address gets assigned different VLANs.

What's the correct way to configure this so that it works?