H2U function key

Status
Not open for further replies.

scotru2

Customer
Basic Certified
Joined
Jun 9, 2021
Messages
6
Reaction score
0
I can program the speed dials using BLF 1-10. How can I program the Fanvil H2U's single DSS/Function button using 3CX?
 
Hi,

Then you already know know how to do it :)
Set it up like this on position 1 (speed dial, or custom speed dial), then reprovision the phone.
After it reboots, the bottom right button can be used to call that extension.

1658904708446.png
 
So I’ve got 1 and 2 programmed for custom speed dials in 3cx but they get dialed on the phone when I hold down 1 or hold down 2 respectively–not when I use the bottom right key. I can program the DSS key in the phone UI but can’t figure out how to do it in 3CX (and if I program in the UI, it seems like eventually 3CX reprovisions and wipes it.
 
How can I program the Fanvil H2U's single DSS/Function button using 3CX?
Your original question was how to program the single key, and that's what the solution above provides.

Now for the long-press speed dials, you will have to do them manually from the device UI from here specifically:
1658907061919.png

These will not get wiped upon reprovisioning / reboot because 3CX does not provision this section.
 
So I’ve got 1 and 2 programmed for custom speed dials in 3cx but they get dialed on the phone when I hold down 1 or hold down 2 respectively–not when I use the bottom right key. I can program the DSS key in the phone UI but can’t figure out how to do it in 3CX (and if I program in the UI, it seems like eventually 3CX reprovisions and wipes if.
 
Status
Not open for further replies.