Have to run 3CXWizard after every reboot

[AndyC3PO]

I have 3CX installed on Debian on an Intel NUC.

This is a new installation, and it went relatively smoothly - a couple of minor mishaps with IP addressing/DNS servers that I performed a clean install on to resolve.

My issue is that every time I reboot the box, I have to logon locally and run /usr/sbin/3CXWizard --cleanup
This is even occurring after a fresh, perfectly executed install, and it's consistent - it never works after a reboot until I do this.

When I try to access the web page in IE, I get page can not be displayed. When I try in Firefox I get a spinning bar followed by a "Server Error" message, behind which is a "DNS_NAMES_RESOLUTION" message (nothing more).

I haven't even gotten to the point of activating this yet.

Anybody have any suggestions on this?

Thanks,
A3CPO

 

[YiannisH_3CX]

Hello @AndyC3PO

When you perform a reboot and the NUC machine comes back up do the phones register? I mean does the PBX work at all? It could be the case that the management console times out and does not start so you are not able to access the management console.
After a reboot access the machine with SSH and check if all services are started (service 3CX* status) and let us know.