Patton 4112 Configuration

[dnut]

Hello,
I'm not able to make this gateway up and running.

I followed the instructions here: https://www.3cx.com/voip-gateways/patton-smartnode-sn4112/

I firstly upgraded Patton 4112 to the last available firmware
Then configured SIP Trunk as explained in the guide
I loaded the config file in the Patton
Then I configured a generic outbound rule.

I'm able to receive calls, but unable to make an outbound call.

Any idea?

Thank you for the support

Here the screenshot of the configurations: https://goo.gl/photos/zNq6kar7DxB2WaYH6

Here the log of a single call attempt (also attached here): https://drive.google.com/file/d/0BxXe6dpaQIPqeHQ4Vmc0bG55dDA/view?usp=sharing

 

[JasonNadeau]

Can we get the config file you're using in the patton as well please ?
... might need you to SSH in to the patton and turn on fxo debugging :
enable
configure
debug ccfxo
debug fxo
debug call-control
debug call-router
debug context sip-gateway transport
debug context sip-gateway error

... don't forget to turn off debugging (if you turn it on) : no debug all