Solved SBC RaspPi 3

[AEGIS_SEC_SOL]

I have a raspberry pi 3 that was on V16, I created a fresh install with V18. what is the easiest way to configure it for V18 new instance.

 

[ChrisC_3CX]

By fresh install do you mean you did not restore a v16 backup? I'm asking because had you done so, you should've still been able to see the SBC in the PBX SIP Trunks section.

If you have not restored a backup you will have to re-install the SBC. Create the SBC entry on the PBX in the SIP Trunks section and then do the following:

If running Debian 9 for Raspberry try:
• SSH to the Pi
• Run the following one-by-one:

sudo apt remove 3cxsbc --purge

sudo apt autoremove

sudo apt autoclean

sudo apt update

sudo wget https://downloads-global.3cx.com/downloads/sbc/3cxsbc.zip -O- | sudo bash

• Proceed with the installation.



If running Debian 10 for Raspberry try:

• Run the following one-by-one:

sudo apt remove 3cxsbc --purge

sudo apt autoremove

sudo apt autoclean

sudo apt update

sudo wget https://downloads-global.3cx.com/downloads/misc/d10pi.zip; sudo bash d10pi.zip

• Proceed with the installation.


If you face any issues with the above, you might want to consider re-flashing the SD with Debian 10 for Pi and configuring the OS and the SBC from scratch: https://www.3cx.com/docs/installing-pbx-raspberry-pi/

 

[AEGIS_SEC_SOL]

Thank you. I went ahead and upgraded to Raspberry pi 4, so that it is easier for future upgrades.

 

[ChrisC_3CX]

Good call!

As this seems to be sorted I'll be marking it as solved!

Do let us know if you need anything else!